Search results

Change your tie-rod ends, you will be fine.

Yes, clean the throttle body. Mileage will slightly increased but performance will be increased much.

Corollas are known for their low maintenance cost, economical on fuel and reliable cars. GO for it and you will love it. The only problem with this model is its AC compressor if you are driving it on all the time.

Here you go. Check the link below for complete flushing :) http://www.toyotanation.com/forum/132-9th-gen-corolla-1st-gen-matrix-2003-2008/325325-diy-2003-2008-corolla-matrix-vibe-transmission-fluid-strainer-replacement.html

The delay and jerk is either due to inside valves problem or if the fluid properties are not good. Have you done with flushing the transmission?

Well Thanks for correcting me. I am having 2008 model and there is no traction control as it is equipped from 2010 model and above. This information is new for me.

You can buy the small code reader device compliant with OBD-II. you can then connect this with your mobile via blue-tooth or wifi and you can read the quote. For your information there is no traction control on this economical vehicle.

Well I am not familiar with this model of corolla but generally the speed sensor is on the top of transmission.

Read the Quran with Translation, you will understand the meaning or life

You should ask the question in the 1st instance.

Check if this noise change when you press the brake. This noise could be brake pad with the disc. Have a look on them.

No special tools are required. But some times the control arm stuck from the rear. You need to pull it hard or use hammer. I think last week someone also asked the same question.

Rub rub sound should be tires. Shocks should be able to find in junk yard

No Special tools are required unless you are replacing the bearing inside the hub. If you are changing complete hub, go ahead and change it. You only need to go for alignment after this job.

Are you sure that your car was on level when you checked? It is always recommended that you only check the oil in the morning keeping your car stand still over the night so that all the oil in the engine drop to the sump pan. Once you start the engine you will not get that level again because...

If it is basic option corolla then there will be no adjustment for steering.

ofcourse you will get it. Go to dealer or parts store for Toyota.

Actually no need to change the filter unless it is damaged. Infact in Engineering language we call it strainer (not filter). If you dont flush your transmission half of the oil will remain in your oil cooler and Torque convertor. The best is to flush or you dont have the equipment then you...

You need to check your brake pads. If they are wear out you need to replace them. Also you need to do facing of the brake disc. Also you need to remove the caliper pins. Clean the caliper pins and re-grease them. Remember use only silicon based grease. this will solve your problem. I had same...

Yes, I checked. Infact I simply replaced with the new tensioner. The leak is gone now I guess. But the Vibration is still there.