Search results

Check for error codes.

You need to flush your transmission.

Here the labor is more for alignment with shims and rear torsion beam I can find from the used market in cheap. But I am thinking to wait to see if the tires which were moved to rear should show any sign of cupping. Because I believe that the tires are cupped because of more load.

The answer to your questions are: 1. The rear tires were cupped and put them on front. 2. as I rotated the tires a month ago, so the front tires are moved to back which are not cupped. 3. Well, I replaced all 4 shocks (with used ones) but it is an year ago and 2 days ago I checked my vehicle and...

Your idle control valve is not calibrated. you need to calibrate that

If only blown gasket than you can replace from there. But if the gasket is stick to the engine block it is very hard to remove and chances are that the debris may fall inside the engine block. You need to very careful while doing this. Otherwise you can remove the engine.

Hi, I am driving 2009 corolla and using Toyo tires, I am facing cupping issue between the middle and inner edge on the rear tires. I was rotating them regularly every 5000 kms for first 30k kms. But on this rotation I waited till 10k and when I rotated the tires the front tire (which were at...

Check you shock absorber and lower arm for bends. Better to change both of them.

Its very easy to do for the manual. No worries so no thread of video required. Just open the bolt, remove the oil and put the new oil as per the quantity in the manual. Dont forget to reinstall the drain bolt before filling :P

and don't forget to use silicon based grease once you clean the pins

Usually workshop people dont re-grease the pins. You need to remove the pins. clean them and re-install. But the damage is already done. You need to face your discs.

My 2 cents are: Did you use silicon based grease for your caliper pins? Normal grease burned with the heat and caliper pins can no longer work smoothly. This will case your rotor to wear unevenly.

Check the rubber washer of both the cylinder. Most probably slave cylinder has issues but check both.

Hi Gregory, I performed the flush on my car it is 2008. Here in the middle east this model came in advance. The flush is pretty simple.Follow the below procedure: 1. First you need to locate that there are two line connected to the radiator cooler. The rule of thumb is that the line which is...

Very Good work.

Perhaps you messed up her AC. Now get it fixed.

Are you sure you need those replacement parts when they changed it?

do you mean that you can crank the engine and still the car is not starting? What I understand from you is that the starter even not rotating the engine.

What your idle rpm ?

Check your sensors. It should be either relay or sensor.