Search results

My turn signals are tail lights as well, nobody to film so i showed what i could haha

These are my taillights and they have caused zero issues, sounds like something else might be your culprit. Have you scanned for codes yet?

I went with Infinity speakers with a Rockford Fosgate 12" sub, very clean crisp sound with some bass, transformed the sound of the car. Nice bang for your buck system. Here is a nice little write up someone did on Toyota nation that goes in depth into the sound system of this car...

The sooner you do this the better too, was a lot easier to do this the first week after i bought my Corolla than my Maxima that had been on there for 9+ years.

Heat them up slightly, to much and you ruin the paint. Then use floss and hit it with some polishing compound after. 5 minute job

go for it, i have one and its not annoyingly loud and doesnt drone much. Plus it doesnt sound like a honda.

The Falken pro G4's are crap by the way, horrible rain handling and even worse in the snow from my experiences.

That needs to be tightened down to somewhere around 184 ft/lbs. too or else it will loosen up and clunk around just FYI

You will want the strut brace next.

that price is what gets me though, 70 bucks for little pieces of plastic? Ill stick to debadging and paint.

The removal goes hand in hand with the prep work. I have done this type of thing on a couple of my friends cars and as long as you had a nice clean surface and the correct amount of layers it came of easy. With that being said i would avoid only doing the hood as it will look gaudy in my opinion.

Running TRD wheels now, 18x7.5 +42 offset with a 3mm spacer to get it back to the factory +39 offset. Tons of room to go further. Im looking into a set of 17x8 +35 right now based off some measurements I took, although that might require some slight fender modification to not rub. All depends...

If it has the cut out in the bumper (not sure if all models do or not) it will fit.

it helps noticeably. pair it with front strut bar, h-brace etc. and you have a nice handling car

No tint just used a crappy phone camera for the pictures and videos, I had some tint laying around and thought about using it but driving in Chicago traffic traffic everyday i like my tail lights as bright as possible...not that it helps stop people riding my bumper

You have to use resistors or else they will.

If its the little plastic thing it is used to help direct air flow for better gas mileage. I took mine off and gas mileage hasnt been affected one bit.

This is how i did mine

Ran it through the passenger side grommet as well, I found it easier the second time (long story) to pop the grommet out run the wire through it and pop it back in. I have all my signal cables running down the drivers side so thats why i choose to route it through the passenger side.

Im willing to bet a better intake manifold would benefit these cars the most but since aftermarket options are non existent and i cant weld i guess im s.o.l.