Hi Guys,
So here is the update / how to install the dash cam in the 2014 Corolla.
I am using Blackvue DR550GW-2CH: this gives me coverage of front and rear.
Also, using PowerMagic Pro which allows me to hardwire camera into the car which is using constant 12V.
As you all know, Corolla's hazard switch fuse is beside the engine which is impossible to hardwire into. So, I had to find different fuse to tap into.
2014 Corolla has secondary fuse box beside the foot pedals. There is fuse called "Stop" which I found out that it will provide constant 12V power which I will need to run the camera.
So, took out the PowerMagic Pro and started the Installation and it will look like this.
After I installed the two wires: 12V wire (Yellow) and ACC wire (just ACC need for I don't know... Just told me to find some fuse where the power comes on when ignition starts) and installed the ground.
When you open the camera box they is a cigaret lighter port will need to inserted into the female part of cigaret jack from the PowerMagic Pro.
At this point, I have established the connection with the camera and started to put things together more nicely.
After all the cameras are installed, all I had to do was cable management which was not too bad. Just used some zip straps to tide the wires and placed in the empty compartment.
After all is done, then the installation was finished.
Hope this helps in your dash cam install
So here is the update / how to install the dash cam in the 2014 Corolla.
I am using Blackvue DR550GW-2CH: this gives me coverage of front and rear.
Also, using PowerMagic Pro which allows me to hardwire camera into the car which is using constant 12V.
As you all know, Corolla's hazard switch fuse is beside the engine which is impossible to hardwire into. So, I had to find different fuse to tap into.
2014 Corolla has secondary fuse box beside the foot pedals. There is fuse called "Stop" which I found out that it will provide constant 12V power which I will need to run the camera.
So, took out the PowerMagic Pro and started the Installation and it will look like this.
After I installed the two wires: 12V wire (Yellow) and ACC wire (just ACC need for I don't know... Just told me to find some fuse where the power comes on when ignition starts) and installed the ground.
When you open the camera box they is a cigaret lighter port will need to inserted into the female part of cigaret jack from the PowerMagic Pro.
At this point, I have established the connection with the camera and started to put things together more nicely.
After all the cameras are installed, all I had to do was cable management which was not too bad. Just used some zip straps to tide the wires and placed in the empty compartment.
After all is done, then the installation was finished.
Hope this helps in your dash cam install