Dash Flip Door

P

plasti rolla

HOONIGAN
#3
#3
Velcro it from the inside if you do it right no one can tell and it will still be useable. You can get velcro strips at walmart in the arts and crafts section cheap.
 
fishycomics

fishycomics

Super Moderator
#4
#4
you mean the coin door on the driver side?

Like don posted.

if it is the coin door and if the stubs are gone? a paper clip, dikes, a needle nose, a lighter. Do a McGyver on it. before Don's time!

using glue will not work. but if the stubs are gone you'll make new ones by implanting your own, then use JB welding 8640 let dry. the stubs on the side must be exact or it will be much harder to open.

go the other route till the velcro peals off, use a stronger, heavy duty Velcro. but clean ALL the oils off, you'll have to sand the pores and oil out of the plastic and use 90-07% ISo.... Alcohol. not alcohol. use less grade is like the oil discussion Lol
 
Last edited:
Donabed Kopoian

Donabed Kopoian

6 Speed Master
#5
#5
A drop of super glue and letting it dry on the stub may do enough. Mine would always pop open if I went over rough road or a speed bump in my '08 Matrix.
 
fishycomics

fishycomics

Super Moderator
#7
#7
million one uses gorilla tape.

if glue does not hold as time it will break away from repeated openings. a light weight bungee, a hole and a spot insied ill be enough to keep force to keep always close and open but held
 
You must log in or register to reply here.
Top