hey guys. I bought some new Infinity tweeters to replace the factory ones. As some of you are aware, the stock ones are connected via a 4-wire harness. My problem is that my tweeters and included crossover are just 2 wires (+&-). For those of you who have done this on your own, how did you do it? I'm not sure which wires to splice or anything. Any help would be great. If not, I guess I'll send it to Best Buy and pay them to deal with it.
Tweeter install advice
- Thread starter shmeaty
- Start date
http://www.kicker.com/44KST2004
I have no complaints. Much better than the stock units. I don't have a lot of power running to them right now but they are crisp and clean.
The 1" model is too big and will be larger than the trim piece on the car. The 3/4" model is a perfect fit.
Kicker 41KST204 3/4" Silk Dome Tweeter - Pair (Black) https://www.amazon.com/dp/B00KC4LQFW/ref=cm_sw_r_cp_api_DcIJybCY2TPE1
I had to order an odd sized hole saw from Amazon to remove the perforations, it was about $10.
DEWALT D180025 1 9/16-Inch Hole Saw https://www.amazon.com/dp/B00005LEZ3/ref=cm_sw_r_cp_api_HaIJybEGFZ018
Then do a little trimming on the inside for a good fit.
I have no complaints. Much better than the stock units. I don't have a lot of power running to them right now but they are crisp and clean.
The 1" model is too big and will be larger than the trim piece on the car. The 3/4" model is a perfect fit.
Kicker 41KST204 3/4" Silk Dome Tweeter - Pair (Black) https://www.amazon.com/dp/B00KC4LQFW/ref=cm_sw_r_cp_api_DcIJybCY2TPE1
I had to order an odd sized hole saw from Amazon to remove the perforations, it was about $10.
DEWALT D180025 1 9/16-Inch Hole Saw https://www.amazon.com/dp/B00005LEZ3/ref=cm_sw_r_cp_api_HaIJybEGFZ018
Then do a little trimming on the inside for a good fit.
