Experimenting with LED's

[Chris Denton]

 

[Chris Denton]

 

[DjAnnexAlpha]

I can dig it. Got some close ups of how you ran the wires inside?

 

[Chris Denton]

I can dig it. Got some close ups of how you ran the wires inside?

It's a work in progress. I just stuck the strip LED's to the underside behind the pinch weld. Used a 12volt battery to power them on, from the outside of the car.
After about an hour, the strip fell off.
I've ordered some 3M VHB to get it to stay on there.
If I make this permanent, I'll be running the wiring up through the fender wells, behind the plastic.
I'm piecing this together, it's not a kit.
So I'm figuring out what will work and then ordering parts. It all comes from China, so it takes about 3 weeks.

I'll keep updating this post with pics.

 

[Chris Denton]

I can dig it. Got some close ups of how you ran the wires inside?

Forgot to mention, there is a rubber plug under the drivers side floor board. When I removed it, I could see the insulation under the carpet. This could potentially be used to run the wiring through the cars interior. Assuming you could seal it back up so it remains waterproof.