2008 Corolla - Please Help Me - Problems (P0328)

#1
Hello friend I had one as problem with my corolla will 2008 happen to be me damage the evaporator of the air, for bring it to a repair center to change after change appeared check on with the code p0328 (knock sensor) checked everything and supposedly everything in order, then I decide to take it to another specialist place toyota-lexus as they searched all sides and found nothing but decided to replace the knock sensor with a new one, all the code was still normal because he decided technician pulling a direct line from computer to the knock sensor to see if it was the problem of the circuit was open, and followed the code on lights it for now, I give you first see it on, after two or three ti ignition is turned off and not come back on until the car is cold, it is intermittent, the cable did the technician did complete including the plugs to see if the line was fine and as usual, the computer is determined that, because according to the manufacturer's manual followed all the steps

* knock sensor replacement
* Check all wiring was fine including making a new one to test and followed the check

told me it's the ecu it is clear that my computer is within the recall and the country I live in Dominican Republic I are going to replace the 22nd is coming from United States already checked everything and I are going to replace for free but I I doubt it because whenever the computer is the ecu gives other code that does not look like that, could someone give me some clue to its successor.
thank you
 
#2
Wait for the ECU replacement and go from there. Faulty ECUs can exhibit a multitude of bizarre behaviors that don't always make it seem the culprit.
 
#4
ello sorry that he had not been able to update here in dominican republic been raining a lot and did not have internet, well then I get the ecu to the dealer change dike was not compactible with mine and verify that I had my lot was no change, for nothing followed with its light and code 0328 last mars happened all this, because we decided to check the connection on the ecu and found they had a sulfated pins actually were not that of the line sensor detonation, but to verify the diagram we saw was one of an injector, as we prodocedimos to clean everything, including card ecu and heat it a little if there was something unsoldered, and installed it to this day not gone takes a week longer, also proce changing petrol and checking regularly and took a week and a few days without again hopefully not go back

thank you
 
Top